Tach for ej20

Discussion in 'Modified Shizzle' started by Bobreoc, Dec 14, 2020.

  1. Morning all.

    I’m looking at installing a tach. Just wondering if anyone knows what signal wire to use?

    cheers
     
  2. @pkrboo ...
    Will know...
     
    Bobreoc likes this.
  3. Who did your loom?

    Sent from my Pixel 4 using Tapatalk
     
    Bobreoc likes this.

  4. Morning. Fellows did the conversion,
    Not sure if they outsource the loom. I think they might so if that’s the case then I’m not sure
     
  5. I paid a bit extra for Fellows to install a tach on mine. I'd had one of those ones that look original in the box for ages and it just seemed easier. Mind they didn't fit the reverse light wire and I still haven't done that, must get round to doing something on that front soon.
     
    Bobreoc likes this.
  6. Can you do a picture of your loom, near the ecu and where is your coolant gauge wired in? The wire/plug may already be there for the rev counter

    Sent from my Pixel 4 using Tapatalk
     
    Bobreoc likes this.
  7. :):)
    yes no problem, I have a day off Thursday I’ll do it then... when we have daylight
     
  8. Also worth asking fellows if they wired it for a rev counter and you may just be bale to run the extra wire needed

    Sent from my Pixel 4 using Tapatalk
     
    Bobreoc likes this.
  9. spoke to fellows. The loom already consisted of a signal wire for a tach and was already behind the clocks.. fitted the tach last night. Got lucky with that one
     
    Valveandy, paradox and pkrboo like this.
  10. Ice one, I though that might be the case. What tach did you fit?

    Sent from my Pixel 4 using Tapatalk
     
  11. [​IMG]
    just a standard 80mm, nothing special

    [​IMG]

    [​IMG]
     
    bernjb56 likes this.

Share This Page