The All New, New "What have you done to your Bay today" thread.

Discussion in 'General Discussion' started by top banana racing, Aug 27, 2015.

  1. Betty the Bay

    Betty the Bay Supporter

    Adjusted the steering, wire brushed the beam and got off all the caked on grease then greased the beam until soft grease oozed out at the ends.
    Quick clean and a coat of stone chip.
    Time for lunch !
     
    nicktuft and Valveandy like this.
  2. Rebuilt the nearside caliper and refitted with a new hose and pads.bled bottom nipplebleed top one tomorrow .


    Sent from my iPhone using Tapatalk
     
  3. Only need to bleed the top ones ;)
     
    paradox and Crispy like this.
  4. So I now realise


    Sent from my iPhone using Tapatalk
     
    snotty likes this.
  5. The air rises to the top ;)
     
  6. DubCat

    DubCat Sponsor

    Thought I'd better tidy up both the inners, cleaned the ali fins up on the other one too and primed and painted the pipe bits.
    [​IMG]
    [​IMG]
    It's actually matte black - paint is still wet :)
     
    nicktuft likes this.
  7. But you have to remember,‘I’m stupid’


    Sent from my iPhone using Tapatalk
     
  8. Lol. I'm sure you're not.
     
  9. Can I lick them :oops:?
     
    DubCat likes this.
  10. On the plus side,I cleared lots of old filthy fluid out the bottom nipple


    Sent from my iPhone using Tapatalk
     
    Zed likes this.
  11. Suss

    Suss Supporter

    You've been self isolating haven't you?o_O
    We can tell!!!!:rolleyes:
     
    DubCat likes this.
  12. I've been painting in my jim-jams!
     
    PanZer likes this.
  13. Nothing for two weeks, back to it tomorrow. I have separation anxiety.

    Spent some time pinging my Ebers guru to find out how to make it work as a fresh-air blower...

    a ebers docs 6s.jpg
     
    matty, DubCat and Crispy like this.
  14. nicktuft

    nicktuft Supporter


    Please give the daff some water.
     
    Lasty, PanZer, DubCat and 2 others like this.
  15. DubCat

    DubCat Sponsor

    :lol:

    It's nearly full! I wondered if anybody'd notice it. My wife's addition this week :)
     
    nicktuft and snotty like this.
  16. DubCat

    DubCat Sponsor

    I worry about you
     
  17. It’s not me. It’s...the others.
     
    DubCat likes this.
  18. Put new cv boots on the offside driveshaft


    Sent from my iPhone using Tapatalk
     
    nicktuft and DubCat like this.
  19. Betty the Bay

    Betty the Bay Supporter

    Took driveshaft off one side to replace CV joints, chaned oil seal on final drive, once again, like the drag link, bolts didn't take any removing but at least a bit more than finger tight.
    Just ready to replace, when a couple of the balls from one CV made an escape bid ( unfortunately successful! )
    Ah well, a job for tomorrow.
    Has anyone a link to reassembly, just for reassurance that I'm doing it right?
     
  20. [​IMG]
    Cleaned up Sliding Door top rail in advance of topcoat for the gutter etc. I just know if I don’t do this first I’ll slip with a power tool or sandpaper and ruin my gutter...it’s happened before
    Bottom rail looks more complicated so might need advice on that


    Sent from my iPhone using Tapatalk
     
    Louise and paradox like this.

Share This Page