Afternoon plumber people. can I use 15mm end feed solder fittings to connect 15mm with 1/2 inch copper tube. Is it the 22mm to 3/4 that gives grief. I can’t remember. Thanks
Or just do what I see all the time. Unload virtually an entire roll of solder, into, onto and around the joint. If you also get huge globs of solder snot to hang off of the fitting and possibly run all over any adjacent pipe work as well then you should be fine.
Cheer folks - I unleashed the roll of solder into it and all good - just off the CPS for more solder and I’ll use that too so should be fine. - I’ll burn Marmite out of the decoration while I’ll at itZ