Torque v Power

Discussion in 'Modified Shizzle' started by Zed, Sep 27, 2016.

  1. For your memory.
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    I'll have a play.
     
  2. Zed

    Zed Gradually getting grumpier

    Not much scope for moving the push rod cup?
    Do you have the means of measuring distance from swivel centre to adjuster and cup centres plus distance between adjuster and cup centres? If I knew those I could work out how far to move the swivel hole. :)
     
  3. If I get time I'll measure it up at work tomorrow.
    How do i know if I have an exhaust rocker?
     
  4. [​IMG]
     
  5. Zed

    Zed Gradually getting grumpier

    They are the more angled ones.
     
    oscar likes this.
  6. Zed

    Zed Gradually getting grumpier

    I'm told if I do the inlets too I'd end in with more exhaust to exhaust and gain less in terms of rpm. But I'm not completely convinced so a full set to mess with would be good. Also good would be 1700 ones which are lighter with 8mm adjusters rather than 10mm the rest have. :)
     
  7. Done hopefully. That was a bugger to measure but it should be pretty close.
    [​IMG]
    [​IMG]
    Can email you a step or iges file of the 3d model if that helps.
     
    Zed and paradox like this.
  8. Your more than a pretty face


    Sent from my iPhone using Tapatalk
     
  9. Zed

    Zed Gradually getting grumpier

    1.4:1. The internet and everyone on it says 1.3:1 so that's an interesting start.

    My CAD is a decade behind yours (and the rest!) but I can play with the dimensions. :)

    Ta very much. :thumbsup:
     
    paradox likes this.
  10. Zed

    Zed Gradually getting grumpier

    Ah, I make it 27mm from shaft centre to rod centre "along the arm", which makes it 1.3:1.
    Next time you're at work @oscar could you check that dimension? Ta. :thumbsup:
     
  11. I'm trying to get my head around the arc being at an angle to the pivot...
     
  12. Zed

    Zed Gradually getting grumpier

    It's not?
     
  13. But it is, so yours first call of 1.4:1 would be right...
     
  14. Zed

    Zed Gradually getting grumpier

    No, definitely not, it's 1.3. Oscar is checking the correct dimension for me.
     
  15. Zed

    Zed Gradually getting grumpier

    What I guessed at 27 is 26.68 making the ratio 1.33:1.
     

Share This Page