Hi I need to get some extra 12v sockets inside my bus, I need to route these from the engine bay into the bus, I have belly pans fitted so I was thinking of running them vertically up though the top of engine bay and then behind rear seat? Anyone have a better idea?
In my Devon Moonraker, it's straight up the right hand side from the battery area to inside just under window level, then along to a fuse box in a cupboard. Not the best pic, but it shows the cable entry.
Mine are routed via two 10mm holes from battery compartment upwards into recess on the rear inside side panel. The recess goesupwards 6 inchesor so and the runs foward behind the spare wheel. I used white silicon sealant to coat 2 single cables hold the cables in place, assisted with so lorry drivers tape while it dried. Worked well and saved using clips. Mines a full width bed,. If you have a side cupboard then you can hide the wiring easily.
If your bus has a 12v fridge fitted, you could share the cable route for your new electrics. That's what i did for the reversing camera and extra lighting.