Window winder handle removal?

Discussion in 'Mech Tech' started by F_Pantos, Jan 12, 2020.

  1. From memory, they’re either 6 or 8mm, but might be different if one door’s been changed (mine were). Best to measure.
     
  2. Anyway I hope the window winder mech and innards
    Are all good
    Because you will have to unclip the cards again without breaking the clips away from holes on the door cards
    And then reaching up inside the door and try to locate everything into place
    Without sawing into your forearm on the rough
    Metal of the door :)

    not forgetting you will have to take all the membrane off again :thumbsup:
     
    F_Pantos likes this.
  3. Just flattening out the door cards where the damp got to them, used PVA, as suggested, big weights holding them flat while they dry. New door speakers on their way. New membranes already here :)

    IMG_20200125_153429~2.jpg
     
  4. I've seen some weights like that around here somewhere I always wondered what they were for :D
     
    F_Pantos likes this.
  5. Bungholes.
     
  6. Beg pardon?
     

Share This Page