Window winder handle removal?

Can anyone advise..how do I get this off without damaging the plastic? I'm sure there's a trick to doing it. Thanks

 

Peel the top plastic bit off the metal handle inside, then undo the mounting screw.

 

Just to be certain, peel back at the spindle end? Thanks

 

Like this:

 

Yep. The plastic cover’s just clipped over the metal handle.

 

If you get stuck i`ve got a blowtorch ...

 

Got it thanks Fiddly little so and so, got to get it just right and it pops off.

 

You're not helping
Drill through the door then knock it off with a club hammer

 

Some sod has already done that, Bazza. Cut a dirty great hole for a speaker which is also fecked, which is why this all started.

 

This speaker is pining for the fjords.... fecked driver, bloody plastic cone, no way I know to fix a plastic cone

 

Typical water damage to the rear of the card too....

 

Give it a scrub with bleach, then a dollop of PVA. Fit a door membrane if you haven't got one.

 

From the pic I cant see if it's become unattached or just split, you could try to reattach the cone with contact adhesive if it isn't split, just be careful not to pull the cone off-centre.

 

What's the preferred supplier for a new membrane? A sheet of polythene from the local DIY store and a craft knife? Then cut to size.

 

Split, I think.

Found the same set on eBay for £18 plus p&p, "NOS" in box, I'm beginning to think that's probably the simpler option. Lowthers they are not!

 

There used to be someone on fleaBay doing them pre-cut. Or could cut your own. Bit of a chore.

 

Heat it up or it'll break....ask me how I know

 

Some here, but they have no holes pre-cut. Need to cut and flap them over the door vents, or water will get in.

https://www.ebay.co.uk/itm/Volkswag...268356?hash=item4b548ff784:g:3O4AAOSwMjtb5W8U

 

Thanks