Tinware

Discussion in 'Mech Tech' started by iblaze, Jan 15, 2019.

  1. iblaze

    iblaze Supporter

    This piece of tinware was supplied by the Po
    But im unsure how it fits.
    Also i assume something goes on the other side but i don't have anything to fit there anyone point me in the right direction please.
    [​IMG][​IMG][​IMG][​IMG][​IMG][​IMG][​IMG][​IMG][​IMG][​IMG]

    Sent from my SM-G960F using Tapatalk
     
    iblaze, Jan 15, 2019
    #1
  2. vw newbie

    vw newbie

    Yeah that side is in the right place just needs a little manipulating to get in place properly the other side I purchased from schofields

    Sent from my JSN-L21 using Tapatalk
     
    vw newbie, Jan 15, 2019
    #2
    iblaze likes this.
  3. vw newbie

    vw newbie

    Pic[​IMG]

    Sent from my JSN-L21 using Tapatalk
     
    vw newbie, Jan 15, 2019
    #3
    iblaze likes this.
  4. davidoft

    davidoft Sponsor

    You need to trim the bit by the pillar to make it fit
     
    davidoft, Jan 15, 2019
    #4
    theBusmonkey likes this.
  5. iblaze

    iblaze Supporter

    Ahh thanks
    I was beginning to think the tin was a cheap replica

    Sent from my SM-G960F using Tapatalk
     
    iblaze, Jan 15, 2019
    #5
    davidoft likes this.
  6. mikedjames

    mikedjames Supporter

    You did remember to cut the stamped on chassis number off the old bit...and weld it on the new bit ?
     
    mikedjames, Jan 18, 2019
    #6
    snotty and Davipon like this.
  7. iblaze

    iblaze Supporter

    Unfortunately the chassis was replaced by the Po
    and he didn't :-(

    Sent from my SM-G960F using Tapatalk
     
    iblaze, Jan 18, 2019
    #7

Share This Page