While rummaging through the computer prior to backing up and clearing some stuff off my over stuffed hard drive l discovered this that l did ages ago. Anyone with a T4 engine will know that the rubber grommets and stuff are not the easiest to come by. Add to that that when you do they are usually past their best so l set myself a task of making the grommet that goes around the oil pressure switch. I discovered a small ball joint cover and grommet...... Go together quite nicely...... And make a nice cover for the switch. It's not the best but it does cut down on the gapping hole that is there, costs next to nothing and took seconds to fit. FYI the burnt wire was replaced.
I like fixes like this. Very nice. Have you ever applied for a job on Blue Peter, or more current...Mr Maker.
