Oil filler/breather

Discussion in 'Mech Tech' started by iblaze, Jul 4, 2019.

  1. iblaze

    iblaze Supporter

    So now I have it off is it supposed to have a gasket to stop it leaking?
    Or do I just do it really tight.
    Also should I flush it with something b4 putting it back on?[​IMG][​IMG]

    Sent from my SM-G960F using Tapatalk
     
  2. Yes it should. I’ve got a ton of suitable ones in a drawer, so if you PM me your address, I’ll send you one.
     
    Baysearcher, paradox and iblaze like this.
  3. mikedjames

    mikedjames Supporter

    nicktuft likes this.
  4. iblaze

    iblaze Supporter

    Does it go on the inside or the outside of the breather?

    Sent from my SM-G960F using Tapatalk
     
    zv6883 likes this.
  5. It goes between the filler and the filler tower. The large threaded "bolt" goes through it.
     
    iblaze likes this.
  6. iblaze

    iblaze Supporter

    Is this hole meant to be there?[​IMG]

    Sent from my SM-G960F using Tapatalk
     
  7. No, are you sure there isnt an ali crush washer stuck to your nut / bolt thingy ?
     
  8. iblaze

    iblaze Supporter

    No definitely not mate

    Sent from my SM-G960F using Tapatalk
     
  9. Weld the little hole up, flappy it off, or buy a new one and it will probably rot in front of your eyes. :)
     
  10. iblaze

    iblaze Supporter

    Done [​IMG]

    Sent from my SM-G960F using Tapatalk
     

Share This Page