Measurement help!

Has anyone got a factory walkthrough and a tape measure handy? I'm retro fitting walkthrough seat supports but need the measurement between the supports before i start welding.

 

Will grab them for you shortly.


Sent from my iPhone using Tapatalk

 

Where exactly do you need measuring. Had a quick look and the front is 400mm, 360mm along the top and 400mm along the weld at the back.

This is for a 1978.

Would pics help?

 

It's the distance where the rubber mat sits. might be easier to measure from one side to the centre of one of the holes that have brake pipe clips in or grommets

 

Beat me to it.


Sent from my iPhone using Tapatalk

 

400mm at the back at floor level.

 

Mmmm i would of thought the measurements would of been equal front to back as the oem rubber mat is parallel but need to know if the mat is a snug fit or slack.

 

Same at the front 400mm

 

Excellent! Very much appreciated

 

It seems to narrow at the top.
This is taken across the top adjacent to the seat runners.