How does this seat attach?!

I have a front bench seat and am a bit puzzled as to how to fit it. My '72 has the normal passenger seat "hooks" to clip the tubular seat frame into. The M501 brackets I have seen have an additional "hook" of the same type to secure the drivers side of the bench seat. However, my seat doesn't have a tubular frame and has some weird pins on the backrest. Presumably I have the wrong seat for my bus, but does anyone know how my type of bench seat is supposed to be fitted?

 

Hopefully the images will be attached now....

 

Does anyone recognise the pin type of bracket on the backrest? I haven't come across them before - some kind of prototype fitting? @davidoft your a bit of a seat expert aren't you?

 

I think perhaps they are for full bulkhead vans as those pins sit higher than a normal bulk head

 

Thanks. I guess i will grind them off and weld a plate on for the normal hook and bracket type arrangement then.

 

You may need to add a bit to the seat as the hooks attach further down

 

I could do, but I have done quite a bit of research and haven't come across any images of this type of fixing thus far.

 

Thanks. You wouldn't happen to have a picture of the back of a "normal" 2/3 front bench seat would you?

 

Possibly I’ll check

 

Possibly for the rear seat of a double (crew) cab.

Will have a look at mine for you later.

Stirlingmoz

 

It’s from a single cab pickup truck. I have one the same which I’m converting to ‘normal’ bulkhead attachment methods when I get round to it.

 

Thanks for confirming. I will grind the pins off and weld a flat bar on the back to fit the normal hook arrangement on.