Hi all, not been on here for a while, busy busy! Blew my engine up a could of weeks back, and done a full top end rebuild as one of the pistons had gone bang! It's all built up so I'm starting to build all the tinware up once I've recieved a few new bits this week... I digress... my question is, if I decide to fit J tubes instead of heat exchangers do I need go blank off anything on the exhaust aswell as the fan housing? I'm thinking of fitting one of those Chinese night heaters. Thanks
I think industrial engines that don't have heat exchangers have a heat shield between the heads and and the exhaust pipes Sent from my SM-T580 using Tapatalk
The heat exchanger is designed to contribute to the efficient flow of air around the engine ( at least as I understand it on a type 4 ) You may need a different under tin, as don't the originals attach to the heat exchanger.
There was a thread on here recently with dimensions for a type 4 alternative tinwear. Thing it's made rather than bought.