Gurt plumbers thread - end feed solder fittings 15 mm to 1/2 inch

Discussion in 'General Discussion' started by Mattlad, Oct 9, 2019 at 1:24 PM.

  1. Afternoon plumber people.

    can I use 15mm end feed solder fittings to connect 15mm with 1/2 inch copper tube.

    Is it the 22mm to 3/4 that gives grief. I can’t remember.
    Thanks
     
  2. jivedubbin

    jivedubbin Moderator

    15mm to 1/2 inch no problems

    22mm to 3/4 your going to need an adaptor
     
    Mattlad and snotty like this.
  3. Or just do what I see all the time. Unload virtually an entire roll of solder, into, onto and around the joint. If you also get huge globs of solder snot to hang off of the fitting and possibly run all over any adjacent pipe work as well then you should be fine.
     
    Mattlad likes this.
  4. Do you have to wrap the mains cable supplying the boiler around the hot pipe, or is that optional?
     
    Mattlad, rustbucket and matty like this.
  5. Tsk!:rolleyes:
     
  6. sounds about right..:thumbsup:
     
  7. Merlin Cat

    Merlin Cat Moderator

    I sensibly get a 1/2 to 15 mm adapter or use a thick olive :)
     
  8. Merlin Cat

    Merlin Cat Moderator

    Actually I’ve forgotten if that’s 22 to 3/4 I’m talking about !
     
  9. Merlin Cat

    Merlin Cat Moderator

    I’m on holiday :)
     
    Mattlad likes this.
  10. Have you been drinking?
     
  11. Do you work with her..?

    Like Olive in on the buses ..:)
     
    jivedubbin likes this.
  12. A few red wines..:burp:
     
  13. jivedubbin

    jivedubbin Moderator


    Educational film showing Olive
     
    art b likes this.
  14. Cheer folks - I unleashed the roll of solder into it and all good - just off the CPS for more solder and I’ll use that too so should be fine. - I’ll burn Marmite out of the decoration while I’ll at itZ
     
  15. jivedubbin

    jivedubbin Moderator

    Don't forget if there's any water in the pipe it takes the heat and the solder won't adhere
     
    Mattlad likes this.

Share This Page