Fitting 1979 front bumper to new deformation panel?

Discussion in 'Restorations' started by Nicolasticity, Jun 28, 2019.

  1. Probably a daft question but on the new deformation panels there are no pre-drilled holes for the bumper. There seem to be three faces at the front and I assume its mid section of the face that is perpendicular to the floor. Is this right or should it be higher or lower?
     
  2. JamesLey

    JamesLey Sponsor

    Yeap pretty much mate. Should be able to see the nuts I welded in below.
    [​IMG]


    Sent from my iPhone using Tapatalk
     
    Nicolasticity likes this.
  3. Grey 2 pack epoxy?
     
    JamesLey likes this.
  4. JamesLey

    JamesLey Sponsor

    Exactly that!


    Sent from my iPhone using Tapatalk
     
  5. JamesLey

    JamesLey Sponsor

    Although I did top coat that as well!
    [​IMG]


    Sent from my iPhone using Tapatalk
     
    Nicolasticity and paradox like this.

Share This Page