Does anyone know how to rem be these bolt holes?

Discussion in 'Mech Tech' started by ZZ, Jun 23, 2018.

  1. ZZ

    ZZ

    Taking off the wheel holder at the front.
    Had to Dremel the end of the bolts as they were spinning (inside the fixing).

    Any ideas on how to rem be the rest of the bolt (just spins inside the fixing).?

    Many thanks [​IMG]


    Sent from my iPhone using Tapatalk
     
  2. Flakey

    Flakey Supporter

    Grind the bit you can see that looks like a washer, the rest will just drop inside
     
    ZZ likes this.
  3. ...and rattle around for all eternity...
     
    ZZ, Bhubesi and Flakey like this.
  4. Pudelwagen

    Pudelwagen Supporter

    Can't you just remove the kick panel and lift the bolts out From the inside?
     
    ZZ likes this.
  5. You’ve got a whopping great airbox on the other side of the panel.
     
    ZZ likes this.
  6. Pudelwagen

    Pudelwagen Supporter

    Not on mine!
     
    ZZ likes this.
  7. Since you're going to have to seal up the holes afterwards, weld a thin piece of rod on to each to stop them falling inside, then get grinding.

    Use same method to get the new bits of metal back into place. Weld up. Voila.

    Rivnuts BTW.
     
    ZZ likes this.
  8. ZZ

    ZZ

    Nice thanks.
    Thanks to all for your advice.


    Sent from my iPhone using Tapatalk
     

Share This Page