Rocker Cover - Weeping

Discussion in 'Mech Tech' started by Little Nellie, Jul 6, 2019.

  1. Faust

    Faust Supporter

    I thought it was Wendy Craig .
     
    Merlin Cat likes this.
  2. Randy old bugger that Shakespeare
     
  3. Little Nellie

    Little Nellie Supporter

    Status Quo- Sweet Caroline. ‘Are you keeping your love, sweet love’
     
    snotty likes this.
  4. I always get The Bard and Francis Rossi mixed up :rolleyes:
     
  5. Little Nellie

    Little Nellie Supporter

    William was the one with the tights and the telecaster
     
    Merlin Cat and snotty like this.
  6. Little Nellie

    Little Nellie Supporter

    Thanks all. Combo of advice seemed to fix things.

    Move to 20w/50 oil, greased new gasket. Plus I found my remaining VW original rocker cover. Sanded it down/ degreased it, bent a corner back true where someone must have prised it of the in the past. Needed some real strength to pull the spring arm closed compared to the newer reproduction - so tighter fit. So now more weeping

    Thanks
     
  7. Another top tip is to put them on with the VW logo upside down, for some odd reason they often seal better that way up.
     
  8. Stupid question. I think. What happens if you use two gaskets one on tops of the other ... making it really tight ... like a gnats chuff .. anybody ever done it? Would cost an extra pound to test, so might be a rip off.
     
  9. DubCat

    DubCat Sponsor

    Think I might have a bash at that - what thickness silicone did you use. Any particular type of silicone? Can you recommend a supplier please?
     
  10. 77 Westy

    77 Westy Supporter

    It would be difficult to keep the second gasket aligned because it wouldn’t be trapped in the recess and you’d add a second leak path (between the two gaskets) and I doubt if the bail would stretch far enough to get over the cover.

    It’s better to fit a single good quality cork gasket and avoid the thin cheap as chips ones. Or better still use silicone gaskets. And of course the bails need to be in good condition.
     
    snotty likes this.
  11. I’m off work today , I will measure the thickness tomorrow ( I think it was 4mm high temp silicone)
    I will see if I kept the quote and company ...
    There is obviously a ton of waste laser cutting them .the ones you buy are moulded..
    I’ll see if I kept the DXF file as well
     
    DubCat likes this.

Share This Page