Didn’t expect anything different mate lol i would be to scared to get yours dirty once it’s finished Sent from my iPhone using Tapatalk
I just priced up all the bits I need for rebuilding it all Jesus !!!!! Sent from my iPhone using Tapatalk
It’s been an expensive month! £300 for new beam plus nearly £400 on rebuilding bits plus koni shocks! Sent from my iPhone using Tapatalk
I priced it up at just over a grand for all new bearings seals shocks pads and joints I think I might have to recheck I haven’t doubled up on stuff Sent from my iPhone using Tapatalk
I’ve not replaced everything btw. I only replaced 1 ball joint (although had to buy another as the guy screwed up the first one so I took it elsewhere). I refreshed the rubber boots on everything else. I’ve not replaced the brake shoes. I’ve not looked at the front calipers yet so suspect I’ve still more to spend. Probably over £500 thinking about it (gave up keeping track tbh)! Shocks were £380ish so a grand all in isn’t far off! Sent from my iPhone using Tapatalk
Another little job done todayand I never thought I would see the day it came of it’s stilts back on axle stands Sent from my iPhone using Tapatalk
Having a few weeks off the bay hit a low point on motivation But on the other hand started to finish of another job which is kitting out the back of the t4 Insulated Ply lined Carpet lined Hopefully couple more weeks and it will be done and then back on with the bay Sent from my iPhone using Tapatalk
So all 4 mounting points cleaned up and a coat of vactan once dry going to give all 4 tubs one more coat of rustoleum then not to sure wether to start stripping the paint in side the bus or rebuild the running gear Is there any real order to rebuilding the under side Sent from my iPhone using Tapatalk
looks gr8 mate ,I know what you mean by low point , money money money , seems neverending get yourself to some vw shows thatl motivate you , it did for me
Well I’m slowly getting back on the bay just finished fitting the new centre pin in the front beam and just finished putting the torsion arms back on with new ball joints I pressed in at work last night Sent from my iPhone using Tapatalk
Oh and I finished the t4 finally and went off camping a couple weeks back Pics if anyone’s interested Sent from my iPhone using Tapatalk
lovely lovely job your doing , smear copper grease on the face of chassis leg and on inner face of beam , will make fitting easier and form a water proof gasket and stop rot , hat s of to ye
Cheers mate took a little longer than expected but I think worked out well in the end Sent from my iPhone using Tapatalk
Got a few hours on it today last coat of rustoleum on the chassis and got the seat runners welded in Sent from my iPhone using Tapatalk